Transmission Neutral Position Sensor -G701-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different variant/trim than selected.

Fig 1: Identifying Noise Insulation

Courtesy of AUDI OF AMERICA, LLC

-- Where equipped, remove rear noise insulation -2-.

-- Move the gearshift lever -2- forward in direction of -arrow- and shift into 4th gear.

Fig 2: Identifying Gearshift Assembly

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Ignore item -1-.

-- Disconnect the connector from the Transmission Neutral Position Sensor -G701- -arrow-.

Fig 3: Locating Transmission Neutral Position Sensor (Through MY 2013)

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolt -arrow- and remove the Transmission Neutral Position Sensor -G701- -A-.

Fig 4: Removing Transmission Neutral Position Sensor

Courtesy of AUDI OF AMERICA, LLC

NOTE:

The cover -B- remains installed.