Transmission Neutral Position Sensor -G701-, REMOVING AND INSTALLING: Installing

WARNING: This page is about a different variant/trim than selected.

-- Install the Transmission Neutral Position Sensor -G701- -A- with a new O-ring in the gearshift shaft cover -B-.

-- Tighten the new bolt -arrow- to the tightening specification. Refer to Tightening Specification .

-- Connect the connector to the Transmission Neutral Position Sensor -G701- -1-.

Fig 1: Locating Transmission Neutral Position Sensor (Through MY 2012)

Courtesy of AUDI OF AMERICA, LLC

-- Install the noise insulation. Refer to OVERVIEW - NOISE INSULATION .