Overview - Gearshift Knob And Cover
WARNING: This page is about a different variant/trim than selected.
- Gearshift Knob
- With shift lever boot
- Removing and installing. Refer to GEARSHIFT KNOB, REMOVING AND INSTALLING .
- Clamp
- Secures the shift lever knob to the shift lever
- Secure using Hose Clip Pliers VAG1275A
- Boot (See Fig 1)
- Available only together with the support ring, refer to -item 4- Support Ring.
- Remove and install together with the noise insulation, refer to -item 5- Noise Insulation, and NOISE INSULATION, REMOVING AND INSTALLING .
- Support Ring (See Fig 1)
- Available only together with the boot, refer to -item 3- Boot.
- Noise Insulation (See Fig 1)
- Removing and installing. Refer to NOISE INSULATION, REMOVING AND INSTALLING .
- Seal
- Nut
- 8 Nm
- Base Plate
- For the shift lever support
- Shift Lever with Shift Lever Support