Selector Shaft, Removing And Installing: Installing

Fig 1: Installing T40216 On Selector Shaft

Courtesy of AUDI OF AMERICA, LLC

-- Install the new o-ring on the selector shaft cover -2-.

-- Remove the Selector Shaft Guide Pins T40216 on the gearshift shaft -1-.

-- Install the gearshift shaft into the transmission -arrow A- and lift it slightly -arrow B-.

Fig 2: Installing Gearshift Shaft Into Transmission And Lift It Slightly

Courtesy of AUDI OF AMERICA, LLC

-- Bring the selector shaft cover -2- into contact with the transmission housing.

Fig 3: Bring Selector Shaft Cover -2- Into Contact With Transmission Cover

Courtesy of AUDI OF AMERICA, LLC

-- Install new bolts -1- and tighten them. Tightening specification. Refer to -item  14- (See Figure).

-- Remove the Selector Shaft Guide Pin T40216.