LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> A4 2.0T >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Controls & Housing - Manual Transmission Internal Components 0B2 (Sedan)) >> 34 Controls, Housing >> Transmission, Disassembling And Assembling >> Overview - Shift Forks

Overview - Shift Forks

WARNING: This page is about a different variant/trim than selected.
NOTE:

Gearshift rails/shift forks installed positions inside the transmission. Refer to Fig 2.

Removing the shift fork group from the bearing brackets for the input and output shafts. Refer to GEARS AND SHAFTS, DISASSEMBLING AND ASSEMBLING .

Fig 1: Identifying Gearshift Rails & Selector Forks
GWWA34-10632Courtesy of AUDI OF AMERICA, LLC
  1. Gearshift Rail/Reverse Gear Shift Fork
  2. Gearshift Rail/Shift Fork for 1st and 2nd Gear
  3. Ball Sleeve
    • Remove and install, for example, using locking ring pliers (for the outer races) from the gearshift rail/shift fork
  4. Gearshift Rail/Shift Fork for 3rd and 4th Gear
  5. Gearshift Rail/Shift Fork for 5th and 6th Gear
    • With yoke for the gearshift rail/shift fork mounting
    • The shift fork cannot be separated from the yoke.
Fig 2: Identifying Earshift Rails / Shift Forks
GWWA34-10633Courtesy of AUDI OF AMERICA, LLC
  1. Gearshift rail/reverse gear shift fork
  2. Gearshift rail/shift fork for 1st and 2nd gear
  3. Gearshift rail/shift fork for 3rd and 4th gear
  4. Gearshift rail/shift fork for 5th and 6th gear
scientia non olet · About LEMON Manuals