LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> A4 2.0T >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Clutch - Manual Transmission 0B2 (Sedan)) >> 30 Clutch >> Clutch Mechanism >> Over-Center Spring, Removing And Installing >> Removing

Over-Center Spring, Removing And Installing: Removing

WARNING: This page is about a different variant/trim than selected.
Fig 1: Identifying Driver Side Storage Compartment
GWWA68-10158Courtesy of AUDI OF AMERICA, LLC

-- Remove the driver side instrument panel cover. Refer to DRIVER SIDE INSTRUMENT PANEL COVER, REMOVING AND INSTALLING .

-- Remove the left footwell vent. Refer to DRIVER SIDE FOOTWELL VENT, REMOVING AND INSTALLING .

Fig 2: Identifying Footwell Vents
GWWA87-10491Courtesy of AUDI OF AMERICA, LLC

-- Actuate the clutch pedal -1- in direction of -arrow-. Press the Over-Center Spring Assembly Clamp T40025 over the stretched over-center spring -2-.

Fig 3: Pressing Clutch Pedal
GWWA30-10156Courtesy of AUDI OF AMERICA, LLC

-- Press the clutch pedal down as far as the stop and remove the over-center spring downward with the assembly clamp.