Codes, Transmission Allocations, Ratios And Capacities (AUDI A5 Coupe From My 2008)

WARNING: This page is about a different variant/trim than selected.

CAUTION:

Gear oil and ATF change Audi RS5

The RS5 gear oil and ATF must be changed.
RS5 change interval. Refer to MAINTENANCE INTERVALS (SEDAN) .
For all other vehicles there is no change interval.

Rear Final Drive			0BF
Codes			LFU	LFV	LFW
Ratio		Final drive Z₂ : Z₁	35 : 9 = 3.889	37 : 9 = 4.111	43 : 13 = 3.308
Driveshaft flange diameter			75.5 mm	75.5 mm	75.5 mm
Gear oil - capacity For rear final drive (differential and pinion) No change interval except RS5 RS5 change interval. Refer to MAINTENANCE INTERVALS (SEDAN) .			Refer to appropriate FLUID CAPACITY TABLE information in MAINTENANCE article .
ATF capacity For the hydraulic control unit and chambers No change interval except RS5 RS5 change interval. Refer to MAINTENANCE INTERVALS (SEDAN) .			Refer to appropriate FLUID CAPACITY TABLE information in MAINTENANCE article .

Rear Final Drive			0BF
Codes			LGH	LGJ	MBV
Ratio		Final drive Z₂ : Z₁	37 : 10 = 3.700	35 : 8 = 4.375	35 : 9 = 3.889
Driveshaft flange diameter			75.5 mm	75.5 mm	75.5 mm
Gear oil - capacity For rear final drive (differential and pinion) No change interval except RS5 RS5 change interval. Refer to MAINTENANCE INTERVALS (SEDAN) .			Refer to appropriate FLUID CAPACITY TABLE information in MAINTENANCE article .
ATF capacity For the hydraulic control unit and chambers No change interval except RS5 RS5 change interval. Refer to MAINTENANCE INTERVALS (SEDAN) .			Refer to appropriate FLUID CAPACITY TABLE information in MAINTENANCE article .

Rear Final Drive			0BF
Codes			MBW	MKV	MKW
Ratio		Final drive Z₂ : Z₁	37 : 10 = 3.700	43 : 13 = 3.308	35 : 8 = 4.375
Driveshaft flange diameter			75.5 mm	75.5 mm	75.5 mm
Gear oil - capacity For rear final drive (differential and pinion) No change interval except RS5 RS5 change interval. Refer to MAINTENANCE INTERVALS (SEDAN) .			Refer to appropriate FLUID CAPACITY TABLE information in MAINTENANCE article .
ATF capacity For the hydraulic control unit and chambers No change interval except RS5 RS5 change interval. Refer to MAINTENANCE INTERVALS (SEDAN) .			Refer to appropriate FLUID CAPACITY TABLE information in MAINTENANCE article .

Rear Final Drive			0BF
Codes			MKX	MKY
Ratio		Final drive Z₂ : Z₁	35 : 9 = 3.889	37 : 10 = 3.700
Driveshaft flange diameter			75.5 mm	75.5 mm
Gear oil - capacity For rear final drive (differential and pinion) No change interval except RS5 RS5 change interval. Refer to MAINTENANCE INTERVALS (SEDAN) .			Refer to appropriate FLUID CAPACITY TABLE information in MAINTENANCE article .
ATF capacity For the hydraulic control unit and chambers No change interval except RS5 RS5 change interval. Refer to MAINTENANCE INTERVALS (SEDAN) .			Refer to appropriate FLUID CAPACITY TABLE information in MAINTENANCE article .