Wiring Harness In Transmission, Removing And Installing: Installing

WARNING: This page is about a different variant/trim than selected.

Install in reverse order of removal. Note the following:

-- Replace wiring harness connector o-rings and lightly coat with ATF.

-- Insert the wiring harness connector into the transmission housing while following the installation position.

-- Install the clip -A- on the wiring harness connector -B-.

Fig 1: Identifying 16-Pin Connector For Transmission Connection

Courtesy of AUDI OF AMERICA, LLC

-- Install the Mechatronic. Refer to MECHATRONIC, REMOVING AND INSTALLING .