Selector Mechanism, Removing And Installing: Installing

WARNING: This page is about a different variant/trim than selected.

Install in reverse order of removal. Note the following:

Tightening specifications. Refer to OVERVIEW - SELECTOR MECHANISM .

NOTE:

Lubricate the ball socket on the selector lever cable with Polycarbamide Grease G 052 142 A2 before installing.

Do not bend or kink the selector lever cable.

-- Adjust the selector lever cable. Refer to SELECTOR LEVER CABLE, CHECKING AND ADJUSTING .

-- Check the selector mechanism. Refer to SELECTOR MECHANISM, CHECKING .

-- Install the driveshaft. Refer to OVERVIEW - DRIVESHAFT for Rear Final Drive 0BC, 0BD, 0BE, 0BF, or 39 FINAL DRIVE, DIFFERENTIAL for Rear Final Drive 0BF and 0BE - Sport Differential .

-- Install the front muffler or the front exhaust pipe. Refer to OVERVIEW - MUFFLER for 2.0L, engine codes CAED, CAEB, CPMB, CPMA, or OVERVIEW - MUFFLER for 3.2L, engine code CALA .

-- Install the front ashtray. Refer to FRONT ASHTRAY, REMOVING AND INSTALLING .

-- Install the Multimedia System Control Head -E380-. Refer to Multimedia System Control Head -E380-, REMOVING AND INSTALLING .