Selector Lever Boot, Removing From Selector Lever Handle: Removing

WARNING: This page is about a different variant/trim than selected.

Fig 1: Identifying Selector Lever Boot From Selector Lever Handle, Removal/Installation

Courtesy of AUDI OF AMERICA, LLC

-- Remove the selector lever handle. Refer to SELECTOR LEVER HANDLE, REMOVING AND INSTALLING .

-- Bind the selector lever handle spring tabs -1- together with cable ties -3-, as shown in the illustration.

-- Slide the selector lever boot sleeve -2- over the tabs on the spring tab -arrow-.

-- Remove the cable ties and the selector lever boot and sleeve from the selector lever.