Left Flange Shaft Ball Bearing Mounting Bracket, Removing And Installing

Special tools and workshop equipment required 

• Press Plate VW401
• Press Plate VW402
• Press Piece - Multiple Use VW412
• Press Piece - 42mm VW516

-- Remove the left flange shaft. Refer to LEFT FLANGE SHAFT, REMOVING AND INSTALLING .

Fig 1: Identifying Circlip -1- In Flange Shaft Groove

Courtesy of AUDI OF AMERICA, LLC

-- Remove the locking ring -1- from the flange shaft.

-- Remove the ball bearing -A- from the flange shaft

Fig 2: Removing Ball Bearing From The Flange Shaft

Courtesy of AUDI OF AMERICA, LLC

-- Install the new bearing bracket -1-.

Fig 3: View Of New Bearing Bracket And Ball Bearing

Courtesy of AUDI OF AMERICA, LLC

• Installed position: the printed side faces the Drive Axle flange

-- Install the new ball bearing -2-.

-- Install the ball bearing -A- all the way on with the bearing bracket -B- installed.

Fig 4: Installing Ball Bearing With Bearing Bracket

Courtesy of AUDI OF AMERICA, LLC

-- Install the circlip -1- in the flange shaft groove.

Fig 5: Identifying Circlip -1- In Flange Shaft Groove

Courtesy of AUDI OF AMERICA, LLC