Rear Final Drive 0BF - Flange/Driveshaft Shaft Seal, Replacing: Notes
WARNING: This page is about a different variant/trim than selected.
Special tools and workshop equipment required
- Puller - Multiple Use VW391
- Puller - Unit Injector T10055
- -2- Puller - Unit Injector - Adapter 2 T10055/2
- Two M 8 x 30 Bolts
- Seal Installer - Hollow Shaft T10380
- Seal Installer - Input Shaft T40222
- Seal Installer - Input Shaft - Guide Sleeve T40222/1
- Sealing Grease G 052 128 A1
- Inductive Heater VAS6414
- or
- Commercially Available Hot Plate
- and
- Digital Thermometer VAS6519