Rear Final Drive 0BE - Replacing, Flange/Driveshaft Shaft Seal: Notes
WARNING: This page is about a different variant/trim than selected.
Special tools and workshop equipment required
- Press Piece - Multiple Use VW431
- Puller - Unit Injector T10055
- Puller - Unit Injector - Adapter 2 T10055/2
- Seal Installer - Hollow Shaft T10380
- Seal Installer - Propshaft T40247
- Seal Installer - Propshaft - Guide Sleeve T40247/1
- -1- Puller - Kukko 2-Arm - 70-180mm 20/10
- Inductive Heater VAS6414
- or
- Commercially Available Hot Plate
- and
- Digital Thermometer VAS6519
- Drip Tray
- Sealing Grease G 052 128 A1