LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> A4 2.0T >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Final Drive & Differential - Rear Final Drive - Sport Differential (Sedan)) >> 39 Final Drive, Differential >> Rear Final Drive, Removing And Installing >> Rear Final Drive, Additional Work After Replacing

Rear Final Drive, Additional Work After Replacing

WARNING: This page is about a different variant/trim than selected.
WARNING:

Malfunctions on the rear final drive.

If the rear final drive was replaced, the following additional work is necessary.

  • Bleed the hydraulic control module using the Vehicle Diagnostic Tester.
  • Program the rear final drive on the All Wheel Drive Control Module -J492- use the Vehicle Diagnostic Tester.
  • The additional work can only be performed when the rear final drive is replaced.

Procedure 

-- Connect the Vehicle Diagnostic Tester and switch on the ignition.

-- On the Vehicle Diagnostic Tester select the function 22 - Control Module, Replacing  under Guided Functions  in the directory 22 - Rear Final Drive, Replacing  .

"Adapt" the new rear final drive to the All Wheel Drive Control Module -J492- with the Vehicle Diagnostic Tester.

NOTE:

A system check will take place when the function 22 - Rear Final Drive Replacing  is complete. If malfunctions appear, then use "Guided Fault Finding  " to correct them.

Tightening Specification 

Component Nm
Wiring harness bracket on the rear final drive 9
scientia non olet · About LEMON Manuals