All Wheel Drive Control Module -J492-, ADDITIONAL WORK AFTER REPLACING
WARNING: This page is about a different variant/trim than selected.
NOTE:
Only perform the additional work only if the All Wheel Drive Control Module -J492- was replaced.
-- Connect the Vehicle Diagnostic Tester and switch on the ignition.
-- On the Vehicle Diagnostic Tester select the function 22 - Control Module, Replacing under Guided Functions in the directory 22 - AWD electronics .
- Follow the instructions given by the Vehicle Diagnostic Tester exactly.
"Adapt" the installed rear final drive to the All Wheel Drive Control Module -J492- with the Vehicle Diagnostic Tester.
NOTE:
A system check will take place when the 22 - Control Module, Replacing function is complete. If malfunctions appear, then use "Guided Fault Finding" to correct them.