LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> A4 2.0T >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Final Drive & Differential - Rear Final Drive - Sport Differential (Sedan)) >> 39 Final Drive, Differential >> Driveshaft, Removing And Installing From Rear Final Drive >> Removing

Driveshaft, Removing And Installing From Rear Final Drive: Removing

WARNING: This page is about a different variant/trim than selected.

Driveshaft, Removing from Rear Final Drive 

Fig 1: Clamping Sleeves
GWWA26-0752Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the exhaust system at the clamping sleeves -1 and 2-.

-- Tie the front exhaust pipe(s) to the underbody.

NOTE:

Do not bend the flex joint in the front exhaust pipe more than 10° or it will be damaged. Tie up the front exhaust pipes on the body and to the side.

A second technician is needed to help remove the rear section of the exhaust system.

-- Remove the rear section of the exhaust system. Refer to EXHAUST PIPES/MUFFLERS for engine code CALA, EXHAUST PIPES/MUFFLERS for engine codes CCBA, CGXC, CTUB, or EXHAUST PIPES/MUFFLERS for engine codes CAED, CAEB, CPMB, CPMA .

-- Check whether there is a color marking on the driveshaft and at flange/driveshaft on the rear final drive -arrow A- and -arrow B-.

Fig 2: Identifying Marked Position Of Driveshaft Flange To Rear Final Drive
GWWA39-10085Courtesy of AUDI OF AMERICA, LLC

-- If one of these markings is no longer visible (for example -arrow A- on the driveshaft), then make a mark for the missing colored dot in color.

Rear Final Drive 0BF 

Fig 3: Counter Hold Using Counterhold Tool T10172 And Adapters T10172/5
GWWA39-10243Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -1- (quantity: 6) from the rear CV joint.

-- Counterhold with Counterhold - Kit - Multiple Use T10172 and Counterhold - Kit - Adapter 5 T10172/5.

-- Remove the driveshaft from the rear final drive and move it to the side of the subframe.

Rear Final Drive 0BE 

Fig 4: Driveshaft Center Bearing Bolts
GWWA39-10506Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -1- (quantity: 6) from the rear CV joint.

-- Counterhold with Counterhold - Kit - Multiple Use T10172 and Counterhold - Kit - Adapter 6 T10172/6.

-- Remove the driveshaft from the rear final drive and move it to the side of the subframe.