Center Differential Ball Bearing, Removing And Installing

WARNING: This page is about a different variant/trim than selected.

Special tools and workshop equipment required

Procedure

Fig 1: Identifying Center Differential

Courtesy of AUDI OF AMERICA, LLC

-- Remove the center differential housing. Refer to CENTER DIFFERENTIAL, REMOVING AND INSTALLING .

-- Remove the center differential -1- from the input shaft.

NOTE:

There are different versions of the center differential -1-.

Fig 2: Ball Bearing Removed From Center Differential

Courtesy of AUDI OF AMERICA, LLC

A - Puller - Kukko Quick Action Separating Tool - 22-115mm 17/2

The Press Piece - Bushing - 50mm Diameter VW432 faces the ball bearing.

Fig 3: Ball Bearing Installed Onto Center Differential

Courtesy of AUDI OF AMERICA, LLC