Driveshaft From Rear Final Drive: Removing

WARNING: This page is about a different variant/trim than selected.

NOTE:

Do not bend the decoupling element in the front exhaust pipe more than 10°, otherwise it will get damaged.

-- Loosen the clamping sleeve(s) -arrows- and disconnect the exhaust system.

Fig 1: Clamping Sleeve Threaded Connections

Courtesy of AUDI OF AMERICA, LLC

-- Tie the front exhaust pipe(s) to the underbody.

NOTE:

A second technician will be needed to help remove the rear section of the exhaust system.

-- Remove rear portion of exhaust system. Refer to EXHAUST PIPES/MUFFLERS for engine code CALA, EXHAUST PIPES/MUFFLERS for engine codes CAED, CAEB, CPMB, CPMA, or EXHAUST PIPES/MUFFLERS for engines CCBA, CGXC, CTUB .

-- Check whether there is a marking (color marking) on driveshaft and at flange/driveshaft at rear final drive -arrow A- and -arrow B-.

Fig 2: Identifying Mark Position Of Driveshaft Flange To Rear Final Drive

Courtesy of AUDI OF AMERICA, LLC

-- If one of these markings is no longer visible (for example -arrow A- on the driveshaft), then make a new color marking.

Die marking on the driveshaft -arrow A- and on the rear final drive -arrow B- must line up.

-- Remove the bolts -1- (quantity: 6) from the rear CV joint.

Fig 3: Removing/Installing Driveshaft Bolts -1- At Rear Final Drive Using Counterhold Tools

Courtesy of AUDI OF AMERICA, LLC

-- Use the T10172 with the T10172/5.

-- Remove the driveshaft from the rear final drive and tie it to the subframe.