LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> A4 2.0T >> Repair and Diagnosis >> External Pages >> Different car >> Section 960 (Cylinder Head, VALVETRAIN- CEUC, CRDB, CTGE, CWUB, CWUC) >> Cylinder Head, VALVETRAIN >> VALVETRAIN >> Camshaft Adjuster Valves, Removing And Installing >> Camshaft Adjustment Valve 1 -N205 - / Exhaust Camshaft Adjustment Valve 1 -N318-, REMOVING AND INSTALLING, CYLINDER BANK 1 (RIGHT) >> Removing

Camshaft Adjustment Valve 1 -N205 - / Exhaust Camshaft Adjustment Valve 1 -N318-, REMOVING AND INSTALLING, CYLINDER BANK 1 (RIGHT): Removing

WARNING: This page is about a different car, the 2018 Audi S6, 2017 Audi S6, and 2016 Audi S6. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .

-- Loosen the hose clamps -arrows- and remove the air guide pipe.

GWWA24-11132Courtesy of AUDI OF AMERICA, LLC
WARNING:

Fire hazards and risk of damage for a faulty engine cover.

  • The engine cover must be always be installed before the hood is closed.
  • The engine may neither be started nor driven without an engine cover.

-- Disconnect the connector -1-.

GWWA28-10077Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolt -2- in question and then remove the valve:

scientia non olet · About LEMON Manuals