Wheel Bearing Unit, Removing And Installing, Fwd Vehicles, Except E-Tron: Installing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal. Note the following:
-- Clean the front seal.
-- Install the front seal and grease the stub axle -arrow- lightly with Grease.
-- Install the brake caliper and the brake rotor. .
-- Install the new cap with the :3241/4 -1-.
NOTE:
Always replace a damaged cap.
Damaged caps allow moisture to get in. Therefore, always use the tool shown.
-- Tighten the wheel bearing unit bolt.
-- Install rear wheel. Refer to WHEELS AND TIRES .