Removal And Installation

WARNING: This page is about a different car, the 2017 Lincoln Navigator and 2017 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.

1.

Remove the rear door trim panel. For additional information, refer to Interior Trim and Ornamentation .

2.

NOTE: There are 2 tabs on the opposite side not shown in the illustration.

NOTE: LF shown, LR and RR are similar.

Unlock the 4 tabs and remove the window control switch from the door trim panel.

Courtesy of FORD MOTOR COMPANY

3.

Remove the rear door speaker.
1. 1.
  
  Remove the screws.
1. 2.
  
  Disconnect the electrical connector.
1. 3.
  
  Remove the speaker.

Courtesy of FORD MOTOR COMPANY

4.

Remove the rear door weathershield.

Courtesy of FORD MOTOR COMPANY

5.

Connect the window control switch.

6.

Lower the window glass to access the window glass clamp bolts.

7.

Disconnect the window control switch.

8.

Loosen the window glass clamp bolts and remove the rear door window glass.
- To install, tighten to 11 Nm (97 lb-in).

9.

NOTE: Secure the rear window glass in the full UP position.

Secure the rear window glass with tape to the rear door frame.

10.

Disconnect the rear door window regulator electrical connectors.

Courtesy of FORD MOTOR COMPANY

11.

Position the interior door handle aside.
- Lift upward on the interior door handle retaining bracket and pivot the interior door handle out of the bracket.

Courtesy of FORD MOTOR COMPANY

12.

Remove the rear door window regulator assembly.
- Remove the bolts.
  - To install, tighten to 11 Nm (97 lb-in).

Courtesy of FORD MOTOR COMPANY

13.

To install, reverse the removal procedure.