Removal And Installation
WARNING: This page is about a different car, the 2017 Lincoln Navigator and 2017 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Left rear door shown, right rear door similar.
- 1.
Remove the door handle screw cover.
- 2.
Remove the door handle screw.
- 3.
Remove the door handle trim bezel.
- 4.
Remove the rear door trim panel finish cover.
- 5.
Remove the 2 door trim panel armrest screws.
- 6.
Remove the door trim panel screw.
- 7.
Remove the 2 lower door trim panel screws.
- 8.
NOTE:
To avoid damage to the door trim panel, lift the door trim panel by pulling directly upward on the armrest to disengage the panel clips.
Remove the rear door trim panel.
- If equipped, disconnect the electrical connectors.
- 9.
To install, reverse the removal procedure.