Removal And Installation
WARNING: This page is about a different car, the 2016 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.
- 1.
Remove the 4 LH and RH rear fender splash shield screws.
NOTE:
Left side shown, right side similar.
- 2.
Remove the 4 LH and RH inner bumper cover nuts.
 Courtesy of FORD MOTOR COMPANY
|
- 3.
If equipped, disconnect the reverse parking aid electrical connector.
 Courtesy of FORD MOTOR COMPANY
|
- 4.
Remove the 2 rear bumper cover lower pin-type retainers.
 Courtesy of FORD MOTOR COMPANY
|
- 5.
Remove the rear bumper cover.
- Remove the 2 rear bumper cover pin-type retainers and the 3 rear bumper cover bolts.
- 6.
To install, reverse the removal procedure.