Removal And Installation

WARNING: This page is about a different car, the 2016 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: For parts identification and locations, refer to Seat - Exploded View, Third Row .

All Seats

1.

Remove the third row seat. Refer to Seat - Third Row .

40 Percent Seat

2.

Remove the safety belt buckle. Refer to Safety Belt System .

60 Percent Seat

3.

Remove the safety belt webbing cover.

GFD137567

Courtesy of FORD MOTOR COMPANY

NOTE: During installation, make sure the safety belt webbing is not twisted and the safety belts and buckles are accessible to the occupants.

4.

Remove the bolt and position the safety belt aside.

GFD137568

Courtesy of FORD MOTOR COMPANY

All Seats

5.

Remove the screw and the inboard slide bracket cover.

GFD137569

Courtesy of FORD MOTOR COMPANY

NOTE: Note the position of the bushings for installation.

6.

Remove the inboard slide bracket.
1. 1.
  
  Remove the inboard slide bracket-to-backrest frame nuts.
1. 2.
  
  Remove the inboard slide-to-inboard motor nut.

GFD137570

Courtesy of FORD MOTOR COMPANY

7.

Detach the backrest cover lower J-clip.

GFD137571

Courtesy of FORD MOTOR COMPANY

8.

Release the backrest cover side J-clip and position the cover aside to access the latch bolts.

GFD137572

Courtesy of FORD MOTOR COMPANY

9.

Remove the power fold seat motor.
1. 1.
  
  Position the seat cushion forward.
1. 2.
  
  Remove the power fold seat motor bolts.

GFD137573

Courtesy of FORD MOTOR COMPANY

10.

To install, reverse the removal procedure.