LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> A4 2.0T >> Repair and Diagnosis >> External Pages >> Different car >> Section 573 (EXTERIOR LIGHTS, SWITCHES (2 of 2) (CABRIOLET)) >> 94 Exterior Lights, Switches >> Parking Aid >> Rear Parking Aid Sensor, Removing And Installing >> Installing

Rear Parking Aid Sensor, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

Install In Reverse Order Of Removal. Note The Following: 

Outer sensor - right side of vehicle, vehicles with 4-cylinder engine:

-- Install the rear aerodynamic underbody trim panel, refer to OVERVIEW - UNDERBODY PANELS .

Inner Sensor: 

-- Vehicles without a trailer hitch, Audi Q5: Install the rear bumper cover, refer to REAR BUMPER COVER, REMOVING AND INSTALLING .

If the bumper cover was removed from a vehicle with lane change assistance, then the Lane Change Assistance Control Module -J769- /Lane Change Assistance Control Module 2 -J770- must be recalibrated, refer to LANE CHANGE ASSISTANCE, CALIBRATING .

scientia non olet · About LEMON Manuals