Halogen Headlamp, Adjusting, Rest-Of-World Vehicles: Notes

• The following test and adjustment description applies to all countries.
• However, national guidelines or regulations of the country should be observed.

Checking and adjusting conditions

• Tire pressure is OK.
• Headlamp lenses must be clean and dry.
• Headlamps lenses must not be damaged.
• Headlamp reflectors and bulbs are OK.
• Vehicle load must be created.

Vehicle load on driver's seat in otherwise unloaded vehicle (curb weight).

• One person or 75 kg.

The curb weight is the weight of the operational vehicle with completely full fuel tank, including the weight of all equipment carried in operation.

• Fuel tank: at least 90% full.
• Equipment: for example, spare wheel, tools, vehicle jack, fire extinguisher, etc.

If the fuel tank is not at least 90% full, the load must be created as follows.

-- Check fuel tank fill lever in instrument cluster tank gauge and compare with the following table. Place additional weight in the luggage compartment, if necessary.

• Roll the vehicle several yards or move it back and forth several times to seat the springs.
• The electromechanical parking brake must not be engaged so vehicle is not under stress.
• The vehicle and headlamp adjusting unit must be on a level surface.
• Headlamp adjusting unit must be aligned to vehicle, refer to the Headlamp Adjusting Unit Operating Instructions.
  Fig 1: Headlamp Adjuster Distance

  Courtesy of AUDI OF AMERICA, LLC
• The headlamp adjuster must be distance -a- 30 to 70 cm in front of the headlamp and should not deviate more than dimension -b- = 3 cm from the headlamp center point.
• Adjust the angle dimension on the headlamp adjusting unit, refer to the Headlamp Adjusting Unit Operating Instructions.
• The angle dimension -arrow- is stamped on the upper edge of the headlamp -1- in "%".
  Fig 2: Identifying Angle Dimension

  Courtesy of AUDI OF AMERICA, LLC