Inspection [08/2013 - ]

WARNING: This page is about a different car, the 2014 Lexus ES 300h. However, it is still accessible from the selected car via links, so may be relevant.

INSPECT SPOT LIGHT ASSEMBLY

Inspect the rear personal lights.

Connect a positive (+) lead from the auxiliary battery to terminal 1 (B) and a negative (-) lead to terminal 3 (GND1).

Fig 1: Identifying Spot Light Assembly Connector Terminal
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Check that the rear personal lights come on as shown in the table below.

Result

Condition	Specified Condition
Rear personal light switch LH on	Rear personal light LH comes on
Rear personal light switch LH off	Rear personal light LH does not come on
Rear personal light switch RH on	Rear personal light RH comes on
Rear personal light switch RH off	Rear personal light RH does not come on

TEXT IN ILLUSTRATION

*a	Component without harness connected (Spot Light Assembly)

If the result is not as specified, replace the bulb or spot light assembly.

Inspect the rear interior light.
1. Connect a positive (+) lead from the auxiliary battery to terminal 1 (B) and a negative (-) lead to terminal 2 (CTY).
2. Check that the rear interior light comes on.
  OK
  
  Rear interior light comes on.
  
  If the result is not as specified, replace the bulb or spot light assembly.
Inspect the rear personal light switch illumination.
1. Connect a positive (+) lead from the auxiliary battery to terminal 4 (ILLB) and a negative (-) lead to terminal 3 (GND1).
2. Check that the personal light switch illumination comes on.
  OK
  
  Personal light switch illumination comes on.
  
  If the result is not as specified, replace the spot light assembly.