Igniter for gas discharge lamps -N195-, removing and installing

WARNING: This page is about a different car, the 2002 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Caution high voltage!

Make sure to disconnect battery Ground (GND) strap before performing work on parts of High intensity gas discharge (xenon) headlights marked with yellow high voltage symbols.

Removing

Remove headlight. Refer to Headlights, removing and installing: .

Fig 1: Identifying Bolts, Retaining Brake, And Igniter

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove bolts -arrows- and retaining bracket -2-.
Remove igniter -1- for high intensity gas discharge (Xenon) from headlight housing and disconnect electrical harness connectors.

Installing

Installation is reverse of removal, paying attention to the following:

Check seal between igniter for gas discharge lamp and headlight housing.
Install headlight. Refer to Installing .

Tightening torque

Component	Nm
Igniter for gas discharge lamp to headlight	1.2