LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> A4 2.0T >> Repair and Diagnosis >> External Pages >> Different car >> Section 431 (Door Lock System (Service Information)) >> Front Door Lock >> Removal [08/2013 - ] >> Removal [08/2013 - ]

Removal [08/2013 - ]

WARNING: This page is about a different car, the 2014 Lexus ES 300h. However, it is still accessible from the selected car via links, so may be relevant.

HINT: 

  1. PRECAUTION 
    NOTE:

    After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery negative (-) terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery negative (-) terminal notices before proceeding with work. Refer to PRECAUTION [08/2013 - ] .

  2. REMOVE LUGGAGE TRIM SERVICE HOLE COVER  . Refer to REMOVAL [08/2013 - ] - Step 2
  3. DISCONNECT CABLE FROM AUXILIARY BATTERY NEGATIVE TERMINAL 
    WARNING:

    Wait at least 90 seconds after disconnecting the cable from the auxiliary battery negative (-) terminal to disable the SRS system.

    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Refer to INITIALIZATION [08/2013 - ] .

  4. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG  . Refer to DISASSEMBLY [08/2013 - ] - Step 4
  5. REMOVE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)  . Refer to DISASSEMBLY [08/2013 - ] - Step 5
  6. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)  . Refer to DISASSEMBLY [08/2013 - ] - Step 6
  7. REMOVE DOOR PULL HANDLE COVER  . Refer to DISASSEMBLY [08/2013 - ] - Step 7
  8. REMOVE COURTESY LIGHT ASSEMBLY  . Refer to REMOVAL [08/2013 - ] - Step 1
  9. REMOVE FRONT DOOR NO. 1 STIFFENER CUSHION  . Refer to DISASSEMBLY [08/2013 - ] - Step 9
  10. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY  . Refer to DISASSEMBLY [08/2013 - ] - Step 10
  11. REMOVE FRONT DOOR INNER GLASS WEATHERSTRIP  . Refer to DISASSEMBLY [08/2013 - ] - Step 11
  12. REMOVE DOOR SIDE AIRBAG SENSOR (w/ Occupant Classification System)  . Refer to REMOVAL [08/2013 - ] - Step 11
  13. REMOVE FRONT DOOR ARMREST SET BRACKET  . Refer to DISASSEMBLY [08/2013 - ] - Step 22
  14. REMOVE FRONT DOOR SERVICE HOLE COVER  . Refer to DISASSEMBLY [08/2013 - ] - Step 23
  15. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY  . Refer to DISASSEMBLY [08/2013 - ] - Step 24
  16. REMOVE FRONT DOOR GLASS RUN  . Refer to DISASSEMBLY [08/2013 - ] - Step 27
  17. REMOVE FRONT DOOR REAR LOWER FRAME SUB-ASSEMBLY  . Refer to DISASSEMBLY [08/2013 - ] - Step 29
  18. REMOVE FRONT DOOR OUTSIDE HANDLE COVER WITH LOCK CYLINDER ASSEMBLY (for Driver Side)  . Refer to DISASSEMBLY [08/2013 - ] - Step 30
  19. REMOVE FRONT DOOR LOCK ASSEMBLY 
    1. Using a T30 "TORX" socket wrench, remove the 3 screws.
      Fig 1: Identifying Front Door Lock Assembly & Screws
      GTY416976Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      TEXT IN ILLUSTRATION

      *1 Front Door Lock Open Rod
    2. Slide the front door lock assembly downward, and remove the front door lock assembly and cables as a unit.
    3. When reusing the front door lock assembly:
      1. Remove the door lock wiring harness seal from the front door lock assembly.
        Fig 2: Identifying Front Door Lock Wiring Harness Seal
        GTY417657Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  20. REMOVE FRONT DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY  . Refer to DISASSEMBLY [08/2013 - ] - Step 37
  21. REMOVE FRONT DOOR INSIDE LOCKING CABLE ASSEMBLY  . Refer to DISASSEMBLY [08/2013 - ] - Step 38
scientia non olet · About LEMON Manuals