Installation [08/2013 - ]

WARNING: This page is about a different car, the 2014 Lexus ES 300h. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL STOP LIGHT SWITCH ASSEMBLY

Insert the stop light switch assembly until the threaded sleeve hits the pedal.

Fig 1: Identifying Stop Light Switch Assembly
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NOTE:
When inserting the stop light switch assembly, support the pedal from behind so that the pedal is not pushed in.
Turn the stop light switch assembly 1/4 clockwise to install it.

Fig 2: Adjusting Stop Light Switch Assembly
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Torque: 1.5 N*m (15 kgf*cm, 13 in.*lbf)

or less

NOTE:
When inserting the stop light switch assembly, support the pedal from behind so that the pedal is not pushed in.
Connect the connector.

Check the protrusion of the plunger.

PROTRUSION OF THE PLUNGER

Area	Measurement
a	0.5 to 2.6 mm (0.0196 to 0.102 in.)

If the protrusion is not as specified, recheck switch installation and inspect brake pedal adjustment if necessary. Refer to ADJUSTMENT [08/2013 - ] .

NOTE:

Do not depress or support the brake pedal.

INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
Refer to INSTALLATION [08/2013 - ]