LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> A4 2.0T >> Repair and Diagnosis >> External Pages >> Different car >> Section 414 (Lighting System (Exterior) (Service Information)) >> License Plate Light Assembly >> Inspection [08/2013 - ] >> Inspection [08/2013 - ]

Inspection [08/2013 - ]

WARNING: This page is about a different car, the 2014 Lexus ES 300h. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSPECT LICENSE PLATE LIGHT ASSEMBLY 
    1. Connect a positive (+) lead from the auxiliary battery to terminal 1 and a negative (-) lead to terminal 2.
      Fig 1: License Plate Light Assembly Connector End View
      GTY329458Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Check that the license plate light comes on.

      OK

      The light comes on.

      TEXT IN ILLUSTRATION

      *a Component without harness connected
      (License Plate Light Assembly)

      If the result is not as specified, replace the license plate light assembly.

scientia non olet · About LEMON Manuals