Inspection [08/2013 - ]
WARNING: This page is about a different car, the 2014 Lexus ES 300h. However, it is still accessible from the selected car via links, so may be relevant.
- INSPECT REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY
- Connect 3 dry cell batteries (1.5 V) in series.NOTE:
Do not use rechargeable batteries as they may not output a voltage of 1.5 V.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
TEXT IN ILLUSTRATION*a Component without harness connected
(Rear Height Control Sensor Sub-assembly)*b Low *c Standard position *d High - Connect the positive (+) lead from the batteries to terminal 3 (SHB) and the negative (-) lead from the batteries to terminal 1 (SHG).
- Measure the voltage between terminals 2 (SHRR) and 1 (SHG) while slowly moving the link up and down.
Standard Voltage
Tester Connection Condition Specified Condition 2 (SHRR) - 1 (SHG) +37.9° (High) 3.77 V 2 (SHRR) - 1 (SHG) 0° (Normal) 2.25 V 2 (SHRR) - 1 (SHG) -36.9° (Low) 0.77 V If the result is not as specified, replace the rear height control sensor sub-assembly.
- Connect 3 dry cell batteries (1.5 V) in series.