LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> A4 2.0T >> Repair and Diagnosis >> External Pages >> Different car >> Section 400 (Interior Panels / Trim (Service Information)) >> Rear Sunshade Assembly >> Inspection [08/2013 - ] >> Inspection [08/2013 - ]

Inspection [08/2013 - ]

WARNING: This page is about a different car, the 2014 Lexus ES 300h. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSPECT REAR WINDOW SHADE ASSEMBLY 
    1. Check the operation of the motor.
      1. Apply auxiliary battery voltage and check the operation of the rear window shade assembly.
        Fig 1: Rear Window Shade Assembly Connector End View
        GTY400010Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

        OK

        Connection Result
        Auxiliary battery positive (+) → 1
        Auxiliary battery negative (-) → 2        		 Rear sunshade raises
        Auxiliary battery positive (+) → 2
        Auxiliary battery negative (-) → 1        		 Rear sunshade lowers
        TEXT IN ILLUSTRATION

        *a Component without harness connected
        (Rear Window Shade Assembly)

        If the result is not as specified, replace the rear window shade assembly.

    2. Check the operation of the limit switch.
      1. Measure the resistance according to the value(s) in the table below.
        Fig 2: Rear Window Shade Assembly (Limit Switch) And Connector End View
        GTY401737Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

        Standard Resistance

        Tester Connection Condition Specified Condition
        3 - 4 Limit switch on Below 1 Ω
        3 - 4 Limit switch off 10 kΩ or higher
        TEXT IN ILLUSTRATION

        *1 Off
        *2 On
        *a Component without harness connected
        (Rear Window Shade Assembly)

        If the result is not as specified, replace the rear window shade assembly.

scientia non olet · About LEMON Manuals