LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> A4 2.0T >> Repair and Diagnosis >> External Pages >> Different car >> Section 379 (Engine Control System (Service Information)) >> Heated Oxygen Sensor >> Inspection [08/2013 - ] >> Inspection [08/2013 - ]

Inspection [08/2013 - ]

WARNING: This page is about a different car, the 2014 Lexus ES 300h. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSPECT HEATED OXYGEN SENSOR 
    1. Measure the resistance according to the value(s) in the table below.
      Fig 1: Identifying Heated Oxygen Sensor Connector Terminals
      GTY316048Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Standard Resistance

      Tester Connection Condition Specified Condition
      1 (HT1B) - 2 (+B) 20°C (68°F) 11 to 16 Ω
      1 (HT1B) - 4 (E2) Always 10 kΩ or higher
      TEXT IN ILLUSTRATION

      *a Component without harness connected
      (Heated Oxygen Sensor)

      If the result is not as specified, replace the heated oxygen sensor.

scientia non olet · About LEMON Manuals