LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> A4 2.0T >> Repair and Diagnosis >> External Pages >> Different car >> Section 379 (Engine Control System (Service Information)) >> Camshaft Oil Control Valve >> On-Vehicle Inspection [08/2013 - ] >> On-Vehicle Inspection [08/2013 - ]

On-Vehicle Inspection [08/2013 - ]

WARNING: This page is about a different car, the 2014 Lexus ES 300h. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSPECT CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY 
    1. Connect the Techstream to the DLC3.
    2. Start the engine.
    3. Turn the Techstream on.
    4. Turn the A/C switch on.
    5. Inspect the camshaft timing oil control valve assembly.
      1. Enter the following menus: Powertrain / Engine and ECT / Active Test / Control the VVT Linear (Bank 1).
      2. Check the engine speed while operating the camshaft timing oil control valve assembly using the tester.

        Standard Condition

        Tester Operation Specified Condition
        0% Normal engine speed
        100% Engine idles roughly or stalls

        HINT: 

        If the result is not acceptable, allow the engine to cool (engine coolant temperature 50°C (122°F) or less) and perform the Active Test again.

scientia non olet · About LEMON Manuals