LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> A4 2.0T >> Repair and Diagnosis >> External Pages >> Different car >> Section 364 (Engine Cooling System (Service Information)) >> Thermostat >> Installation [08/2013 - ] >> Installation [08/2013 - ]

Installation [08/2013 - ]

WARNING: This page is about a different car, the 2014 Lexus ES 300h. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL WATER INLET WITH THERMOSTAT SUB-ASSEMBLY 
    1. Install a new gasket on the water inlet with thermostat sub-assembly.
    2. Install the water inlet with thermostat sub-assembly with the 2 bolts.

      Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf) 

  2. CONNECT NO. 6 WATER BY-PASS HOSE 
    1. Connect the No. 6 water by-pass hose.
  3. CONNECT NO. 2 RADIATOR HOSE  . Refer to INSTALLATION [08/2013 - ] - Step 42
  4. INSTALL ENGINE OIL LEVEL DIPSTICK GUIDE  . Refer to INSTALLATION [08/2013 - ] - Step 18
  5. ADD COOLANT (for Engine)  See step  2
  6. INSPECT FOR COOLANT LEAK (for Engine)  . Refer to ON-VEHICLE INSPECTION [08/2013 - ] - Step 1
scientia non olet · About LEMON Manuals