Installation [08/2013 - ]

1. Pass the transmission control cable assembly from the cabin to the engine compartment.
2. Install the transmission control cable assembly to the body with the 2 bolts.

   Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf) 

3. Install the dash panel insulator to the original position.
4. Connect the transmission control cable assembly to the No. 2 transmission control cable bracket and No. 3 transmission control cable bracket.
5. Install a new clip to the No. 1 transmission control cable bracket.
6. Install the transmission control cable assembly to the No. 1 transmission control cable bracket.
   Fig 1: Identifying Transmission Control Cable Assembly, Bracket & Claws

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   TEXT IN ILLUSTRATION
   
   

   *1	Transmission Control Cable Assembly
   *2	No. 1 Transmission Control Cable Bracket
   *a	Claw (A)
   *b	Claw (B)

   NOTE:

   • Make sure that the claws (A) on the clip are securely fit into the bracket holes.
   • Make sure that the cable is securely installed inside of the claws (B) of the clip.
7. Connect the transmission control cable assembly to the control shaft lever with the nut.

   Torque: 13 N*m (130 kgf*cm, 9 ft.*lbf) 

8. Engage the 2 claws and connect the transmission control cable assembly to the lower shift lever assembly.
9. Slide the slider of the transmission control cable assembly in the direction indicated by the arrow and pull the lock piece outward.
   Fig 2: Identifying Transmission Control Cable Assembly Slider And Lock Piece

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   TEXT IN ILLUSTRATION
   
   

   *1	Slider
   *2	Lock Piece
   *a	Slide
   *b	Pull

10. Install the end of transmission control cable assembly to the lower shift lever assembly.
    Fig 3: Installing End Of Transmission Control Cable Assembly

    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    TEXT IN ILLUSTRATION
    
    

    *1	Lock Piece

    NOTE:

    • Check that the lock piece is pulled up.
    • Install the cable end all the way to the base of the pin.
11. Push the lock piece into the adjuster case.
    NOTE:

    • Check that the shift lever position sensor and the shift lever are in neutral.
    • Securely push in the lock piece until the slider lock is engaged.

1. Install the No. 1 parking brake cable assembly to the body with the bolt and nut.

   Bolt 

   Torque: 15 N*m (153 kgf*cm, 11 ft.*lbf) 

   Nut 

   Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf) 

2. Install the floor carpet to the original position.

Refer to INSTALLATION [08/2013 - ]