Installing clutch release lever

WARNING: This page is about a different car, the 2005 Audi A4, 2004 Audi A4, 2003 Audi A4, and 2002 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Installing Clutch Release Lever

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Before installing the clutch release lever, the contact surface of clutch slave cylinder push rod must be coated with a thin layer of copper paste.
Insert clutch release lever -A- into the intermediate piece -C- and allow it to engage (detent -B- becomes visible).
Insert leaf spring -Item 7: Refer to Clutch release mechanism, servicing , tighten retaining bolt -Item : Refer to 8 Clutch release mechanism, servicing to 25 Nm.