Pinpoint Test E : The One-Touch Up Feature Is Inoperative
WARNING: This page is about a different car, the 2018 Lincoln Navigator. However, it is still accessible from the selected car via links, so may be relevant.
- E1 INITIALIZE THE SUSPECT POWER WINDOW
- Carry out the initialization procedure on the suspect power window. REFER to: Power Door Window Initialization .
Is the one-touch up feature operating correctly?
Yes The system is operating normally at this time. The window lost initialization. No If the one-touch up feature is inoperative for the LH front window, INSTALL a new master window control switch. REFER to:Driver Door Window Control Switch . Test the system for normal operation. If the concern is still present, INSTALL a new DDM. REFER to: Driver Door Module (DDM) . For all other windows, GO to E2 - E2 CHECK THE SUSPECT WINDOW CONTROL SWITCH
- Ignition OFF.
- Carry out the component test on the suspect window control switch. Refer to Wiring Diagram Component Testing for schematic and connector information.
Did the window control switch pass the component test?
Yes For an inoperative RH front window, INSTALL a new PDM. REFER to: Passenger Door Module (PDM) . For an inoperative rear window, INSTALL a new RDM. REFER to: REAR DOOR MODULE (RDM) . No INSTALL a new window control switch. REFER to:Passenger Door Window Control Switch . REFER to: Rear Door Window Control Switch .