Name Badges And Emblems: Notes
Special tools and workshop equipment required
- Roller 3356
CAUTION:
- Badges and emblems that are remove must be replaced.
- The vehicle must reach room temperature before installing the name badge and emblems.
- The adhesive surface on the body must be free of dirt and grease, as well as free of adhesive residue.
- Clean the adhesive surfaces using Cleaning Solution D 009 401 04.
- Warm the adhesive surfaces to approximately 40 °C (104 °F) using a hot air blower.
- After installing, take the roller and press the brand emblems one more time.