LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> A4 2.0T >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Exterior Equipment (Sedan) >> 66 Exterior Equipment >> Molding/Trim/Extensions/Trim Panels >> Sill Panel Trim, Removing And Installing >> Overview

Sill Panel Trim, Removing And Installing: Overview

NOTE:

The sill panel strip is secured to the side member using adhesive strips.

It is not possible to remove without destroying.

Fig 1: Identifying Inner Door Seal
GWWA66-10321Courtesy of AUDI OF AMERICA, LLC
  1. Inner Door Seal
  2. Rear Sill Panel Strip
    • Removing:

      -- Heat the sill panel strip using a hot air gun and pull the molding upward and off.

    • Installing:

      -- The side member must be free of dirt and grease in the adhesive area.

      -- Warm the area where the adhesive will be applied to approximately 40 °C (104 °F) with a hot air blower.

      -- Remove protective film from adhesive tape.

      -- Insert the sill panel strip with the centering pins in the side member and press it on firmly in stages from front to back.

  3. Front Sill Panel Strip
    • Removal and installation same as with rear sill panel strip.
  4. Adhesive Tape
    • Pull off protective foil before installing.
scientia non olet · About LEMON Manuals