LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> A4 2.0T >> Repair and Diagnosis >> Accessories & Equipment >> Mirrors >> Exterior Equipment (Sedan) >> 66 Exterior Equipment >> Roof Bars/Roof Rails >> Overview - Roof Railing

Overview - Roof Railing

CAUTION:

If being re-used, install the nuts and screws with locking compound.

Fig 1: Overview Of Roof Railing
GWWA66-10388Courtesy of AUDI OF AMERICA, LLC
  1. Roof Railing
    • Lower the headliner. Refer to HEADLINER, REMOVING AND INSTALLING (SEDAN) .

      -- Adjusting elements must be pushed into the roof and be in the installation position with slight pretension.

      -- Place railing on roof and threaded pins through adjusting elements.

    • Follow the installation sequence:

      -- First tighten the screws and then the nuts to the tightening specification.

  2. Adjusting Element
    • Insert the front adjusting element and both rear adjusting elements into the holes and slide them forward into their installation position.
    • Insert the remaining adjusting element (second element shown from the front) into the hole and slide it toward the rear into its installation position.
    • Position the adjusting elements so that it makes contact, with light pre-tension of 0.3 Nm.
  3. Nut
    • 10 Nm
  4. Bolt
    • 10 Nm
  5. Roof
scientia non olet · About LEMON Manuals