Spray Nozzles, from 09.07, Adjusting
Special tools, testers and auxiliary items required
- Windshield Washer Aiming Tool T10127 equipped with Replacement Tip 3125/5A
Adjusting
NOTE:
- The settings indicate the values for a moving vehicle, i.e. the spray from the jets is slightly offset when the vehicle is stationary.
- Mark the six points on windshield using a water soluble marker:
| Dimensions in mm | Drivers side | Passengers side |
|---|---|---|
| a= | 280 | 280 |
| b= | 520 | 520 |
| c= | 310 | 310 |
| d= | 305 | 305 |
| e= | 535 | 535 |
| f= | 160 | 160 |
- Aim the individual jets at the points using the setting tool T10127.
- If the spray field does not correspond to the specifications, clean dirty spray jet.
Cleaning the nozzle:
- Remove nozzle → Spray Nozzles, from 09.07, Removing and Installing .
- Flush nozzle opposite to spray direction using clear water.
- To remove remaining impurities, the nozzle must only be blown out opposite to spray direction using compressed air.
- If the spray field still does not correspond to the specifications, replace the spray jet.