Rear Vents, 2-Zone A/C System, Removing and Installing
Special tools, testers and auxiliary items required
- Torque wrench V.A.G 1783/
Removing
Removal is depicted at a rear vent, 2-zone A/C system without seat potentiometer.
Removal with seat potentiometer is performed analogously.
- Remove bolts - 1 - (qty. 2).
- Pull rear air vents, 2-zone A/C system - 2 - out of center console - 3 -.
- Disconnect electrical connectors.
Rear Storage Compartment, Removing
Fig 3: Rear Storage Compartment, Center Console, Rear Center Console Panel, Rear Air Vents, 2-Zone A/C System & Rear Cigarette Lighter
- Switch off ignition.
- Remove the rear storage compartment - 1 - from the center console - 2 -.
3 - Rear center console panel
4 - Rear air vents, 2-zone A/C system
5 - Rear cigarette lighter
Rear Center Console Trim, Removing
- Unclip rear center console panel - 1 -.
2 - Rear air vents, 2-zone A/C system
Cigarette Lighter, Removing
- Rotate cigarette lighter - 1 - in -direction of arrow- until it stops.
- Pull cigarette lighter out of mount in rear air vents.
Installing
Installation is reverse of removal. Observe the following when doing so:
- Follow the installation sequence when installing cigarette lighter and rear center console panel.
- Connect electrical harness connector.
- Insert cigarette lighter with roll pin - 1 - into mount - 2 - in rear air vent.
- Rotate cigarette lighter clockwise until it stops.
- Clip rear center console panel into rear air vents, 2-zone A/C system.
Tightening Specifications
Rear air vents, 2-zone A/C system: 4 Nm