Rear lights in rear fenders, assembly
1 - Housing
- Removing and installing → Rear lights / rear light bulb holder in rear fenders, removing and installing
- Align to body contour → Rear lights in rear fenders, aligning with body contour
2 - Bulb for turn signal
- 12 V, 21 W
3 - 2.5 Nm
- Insert using locking compound; locking compound Parts Catalog.
4 - Clip nut
5 - Retaining element
- For aligning housing to body contour → Rear lights in rear fenders, aligning with body contour
6 - Clip nut
7 - 2.5 Nm
- Insert using locking compound; locking compound Parts Catalog.
8 - Electrical harness connector
9 - Cap nut (3.5 Nm)
10 - Bulb carrier
- Removing and installing → Rear lights / rear light bulb holder in rear fenders, removing and installing
11 - Bulb for brake light/backup light
- 12 V, 21 W
- Does not apply to vehicles with LEDs
12 - Adjustment nut
- With seal
- To adjust tail lamp to body contour
13 - Threaded bolts
- Bolted in side panel