Overview - Instrument Cluster
WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
All warning lamps in instrument cluster are fitted with light-emitting diodes. In case an indicator lamp is malfunctioning, the instrument cluster must be replaced.
- Oil Level Thermal Sensor -G266-
- Removing and installing. Refer to OIL LEVEL THERMAL SENSOR -G266-, REMOVING AND INSTALLING[For engine(s) CAED, CAEB, CPMB, CPMA] .
- Oil Pressure Switch -F1-
- Removing and installing. Refer to Oil Pressure Switch -F22-, REMOVING AND INSTALLING [For engine(s) CAED, CAEB, CPMB, CPMA] .
- Connector
- For Data Bus On Board Diagnostic Interface -J533-
- Data Bus On Board Diagnostic Interface -J533-
- Overview. Refer to OVERVIEW - DATA BUS ON BOARD DIAGNOSTIC INTERFACE .
- Bolt
- Tightening specification. Refer to OVERVIEW - DATA BUS ON BOARD DIAGNOSTIC INTERFACE .
- Fiber Optic Cable Connector
- Seal with Fiber-Optic Repair Set - Connector Protective Caps:VAS6223/9
- Instrument Cluster
- With Instrument Cluster Control Module -J285-
- Removing and installing. Refer to Instrument Cluster -KX2-, REMOVING AND INSTALLING .
- Multi-pin connector pin assignment. Refer to INSTRUMENT CLUSTER MULTI-PIN CONNECTOR CONTACT ASSIGNMENT .
- Connector
- For instrument cluster
- Bolt
- 2.5 Nm
- Gap Cover
- Removing and Installing. Refer to STORAGE COMPARTMENTS AND COVERS .
- Bolt
- 2.5 Nm
- Bolt
- 2.5 Nm
- Fuel Level Sensor -G-
- Connector assignment. Refer to Fuel Level Sensor -G- CONNECTOR ASSIGNMENT .
- Removing and installing. Refer to appropriate service information. .
- Fuel Level Sensor 2 -G169-
- Connector assignment. Refer to Fuel Level Sensor 2 -G169- CONNECTOR ASSIGNMENT .
- Removing and installing. Refer to appropriate service information.
- Radio Frequency Controlled Clock Receiver -J489-
- Removing and installing. Refer to RADIO FREQUENCY CONTROLLED CLOCK RECEIVER, REMOVING AND INSTALLING .
- Bolt
- 2.5 Nm
- Bolt
- 2.5 Nm
- Connector
- for Radio Frequency Controlled Clock Receiver -J489-
- Windshield Washer Fluid Level Sensor -G33-
- Removing and installing. Refer to WINDSHIELD WASHER FLUID LEVEL SENSOR, REMOVING AND INSTALLING .
- Brake Pad Wear Sensor
- Left Front Brake Pad Wear Sensor -G34-
- Removing and Installing. Refer to appropriate service information. .
- Brake Fluid Level Warning Switch -F34-
- Removing and Installing. Refer to BRAKE BOOSTER/BRAKE MASTER CYLINDER .
- Engine Coolant Level Warning Switch -F66-
- Connector
- For Outside Air Temperature Sensor -G17-
- Outside Air Temperature Sensor -G17-
- Removing and installing:
- Vehicles through MY 2012. Refer to Outside Air Temperature Sensor -G17-, REMOVING AND INSTALLING .
- Vehicles from MY 2013. Refer to Outside Air Temperature Sensor -G17-, REMOVING AND INSTALLING
- Removing and installing: