Transmission Control Module, Removing And Installing: Removing
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2016 Audi A4, 2015 Audi A4, 2014 Audi A4, 2013 Audi A4, and 2012 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Refer to REPAIR INFORMATION .
Refer to GUIDELINES FOR CLEAN WORKING CONDITIONS .
-- Remove end cover. Refer to END COVER, REMOVING AND INSTALLING .
-- Remove the cover -A-, if equipped.
-- Remove screws -arrows- and pull out Transmission Control Module -J217- without tilting it.
-- Remove the double lip seal -B- from the Transmission Control Module -J217-.
NOTE:
Do not touch the pins in the connector -A-.
When positioning Transmission Control Module -J217-, make sure the sensor on the control module is not damaged.