Balance Shaft, Removing And Installing: Removing

• The transmission is removed. Refer to TRANSMISSION, REMOVING AND INSTALLING for 0B4, or TRANSMISSION, REMOVING AND INSTALLING for 0B5 .

-- Remove the belt pulley side sealing flange. Refer to SEALING FLANGE, REMOVING AND INSTALLING, BELT PULLEY SIDE .

-- Remove the lower timing chain cover. Refer to LOWER TIMING CHAIN COVER, REMOVING AND INSTALLING .

-- Remove the power take-off drive chain. Refer to POWER TAKE-OFF DRIVE CHAIN, REMOVING AND INSTALLING .

-- Secure the rear balance weight -1- to the engine using the Locating Pin T40116.

Fig 1: Balance Weight -1-

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolt -2- and remove the balance weight from the balance shaft.

-- Remove the bolt -2- while counter holding the balance weight using the drift and remove the balance weight -1- from balance shaft at the front of the engine.

Fig 2: Identifying Balance Weight -1- And Bolt -2-

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -arrows- and the balance shaft and bearing end bracket at the rear of the engine.

Fig 3: Identifying Bearing End Bracket Bolts

Courtesy of AUDI OF AMERICA, LLC

-- Remove the balance shaft back out of the cylinder block.