Adjustment Procedure Using Acc Setting Device: Vas 6430: Notes

WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools And Workshop Equipment Required

ACC Adjustment Device:VAS 6430
Adjustment Tool:VAS 6190/2
Wheel alignment computer

NOTE:

Before driving the vehicle onto the alignment stand, check whether there is a sufficiently large space between the vehicle and the :VAS 6430 . The distance between the :VAS 6430 and the vehicle must be 120 cm +/- 5 cm.

If there is not sufficient space, drive vehicle backward on alignment stand in order to be able to use the corresponding space.

Before performing the calibration procedure, check the position of the calibration mirror. The calibration mirror may need to be adapted before performing the calibration.

The :VAS 6430 must be adapted before adjustment procedure. If this is done during the adjustment procedure, the pre-calibration on the :VAS 6430 must be repeated.

Before beginning the adjustment, check the DTC memory and correct any malfunctions present.

The adjustment procedure is described here with the :VAS 6430 .

If there was a previous axle alignment, the steps under "Calibration procedure without a previous axle alignment" should not performed.