Overview - Front Backrest, Manual Standard Seat: Notes

Fig 1: Exploded View Of Front Backrest

Courtesy of AUDI OF AMERICA, LLC

1. Seat Pan
2. Bolts
   • 33 Nm
   • Always replace if removed
   • Threaded holes for bolts must be cleaned, for example, with a thread tap
   • Self-locking
3. Backrest
   • Removing and installing. Refer to FRONT BACKREST, REMOVING AND INSTALLING, STANDARD SEAT/SPORT SEAT/SUPER SPORT SEAT .
4. Headrest
   • Removing and installing. Refer to HEADREST, REMOVING AND INSTALLING, HEADREST WITH SLIDING LOCKING MECHANISM .
5. Handle
   • With bracket (entry assistance)
   • Removing and installing. Refer to ENTRY ASSISTANCE HANDLE WITH BRACKET, REMOVING AND INSTALLING .
6. Entry Assistance Trim
   • Removing and installing. Refer to ENTRY ASSISTANCE TRIM, REMOVING AND INSTALLING, MANUAL STANDARD SEAT .
7. Wiring Harness
   • Running from the side airbag to the connector station.
   • Depending on optional equipment, there may be more wiring harnesses, such as for backrest heating, lumbar support
8. Cables
   • With entry assist
   • Quantity: 2
   • >>Entry Assistance<< Release Cable A, Removing and Installing. Refer to ENTRY ASSISTANCE RELEASE CABLE A, REMOVING AND INSTALLING 
   • >>Entry Assistance<< Release Cable A, Adjusting. Refer to ENTRY ASSISTANCE RELEASE CABLE A, ADJUSTING 
   • >>Entry Assistance<< Release Cable B, Removing and Installing. Refer to ENTRY ASSISTANCE RELEASE CABLE B, REMOVING AND INSTALLING 
   • >>Entry Assistance<< Release Cable B, Adjusting. Refer to ENTRY ASSISTANCE RELEASE CABLE B, ADJUSTING